CONCRETE CUTTING

CHAINSAW, HYDRAULIC CONCRETE CUTTER

Manufacturer Link: <Click Here>


	Image for reference only Actual item may look different Click on image for larger view

Manufacturer: ICS

Model: 814PRO

Daily: $229.00

Weekly: $915.00

Quantity: for a period of
day(s) week(s)

Additional Information

Features:

http://icsbestway.com/en/products/ICS_814PRO_Datasheet.htm

http://icsbestway.com/en/documents/ICS_ChainLife_TipSheet.pdf

http://icsbestway.com/en/downloads/documents/ICS_814PRO_OpManual.pdf

13" Guidebar
8 GPM Hydraulic
Includes SRS
Only 15 lbs with Bar and Chain
Application:
Cuts concrete and masonry. Recommended for production cutting jobs and frequent use. Ideal for tight sapces and indoor jobs. Can be used underwater.

REBAR
Can a diamond chain cut rebar?

Yes, Number 4 or 5 (12 or 16 mm) bar is not a problem. Anything over number 8 (25 mm) is difficult. Large amounts of rebar will reduce chain life. Caution: Rebar or steel must be surrounded by concrete or aggregate material.

CHAIN LIFE
How long will a diamond chain last?

This depends on the material being cut, chain type, experience of the operator and how much rebar is present. For example, diamond chain on gas saws will typically cut 40 to 80 linear feet (12 to 24 meters) in 6-inch (15 cm) concrete. On hydraulic saws, this range is most often doubled.
Click Here for Diamond Chain Life Tipsheet (PDF)

GUIDE BAR LIFE
How long does a guide bar last?

Normally two or three chains. Heavy rebar can shorten bar life

DRY CUT
Can a concrete cutting chainsaw cut dry?

No. It is a wet cut system. 20 psi (1.5 bar) minimum is required.

KICKBACK
Is "kickback" a safety problem?

No. Wood cutting chain has sharp hooked teeth that can grab the wood causing kickback. Diamond chain grinds through concrete with very small teeth (diamonds) without hooks. The preferred method of starting a cut is to plunge straight into the wall. There is no rotational kickback; however, firm footing and a two-handed grip is required and important for safety.

CUTTING SPEED
How fast will a concrete cutting chainsaw cut?

This also depends on the material being cut, chain type, experience of the operator and how much rebar is present. Gas saws will typically saw 1 foot x 6 inches deep (30 cm x 15 cm) in 2 minutes. Hydraulic saws are faster.
CHAIN TENSION
When does the chain need tightening?

Diamond chains tend to run better when slightly loose. It's normal for the drive-links to hang completely out of the bar. Tighten the chain when the drive-links hang more than 1/2 inch (12mm) below the bar. But remember, you should be able to pull the chain around the bar by hand, otherwise it is too tight.

* Prices are subject to change.

* Please call us with any questions about our chainsaw hydraulic concrete cutter in Whistler BC, serving Squamish, Pemberton, and the Sea-to-Sky Corridor.

CONCRETE CUTTING

CHAINSAW, HYDRAULIC CONCRETE CUTTER

Additional Information

Locally Owned in Whistler: